Adams Machinery Co
6450 N Hamlin Ave
Lincolnwood
IL
60712-4042
Tel: 847-673-0556
Fax: 847-673-7636
adams@adamsmachinery.com
www.adamsmachinery.com
252S Rush, 3/22-2"Cap,2" Hole, 7"X1.25"X1.25"Whl, 40-180° Angle, Diamond Whl, 1990
[1118]
RUSH MODEL 252S SEMI AUTOMATIC DRILL AND TOOL GRINDER
S/N: 1554 New: 1990
EQUIPPED WITH:
For Conventional, Thinned Point, Split Pint, Lip Corrected, Web Thinned And Flat Bottom Drills. Tap
harpening. Ream Sharpening. Endmill Sharpening. Spin And Index Grinding.
Motor Driven with .5 HP, 115/208-230 Volt Single Phase Motor. 6.5" 6-Jaw Chuck. Dual Cam Workhead Fo
Grinding Both Odd And Even Numbered Flutes. Motorized Workhead. Hand Knob For Workhead I
dexing And Set-Up. Abrasive Wheel Flute Finger With Dovetail Cross Feed And Micrometer Vertical Adju
tment. Direct Angle Setting Device. Rocker Arm Fixture For Flute Indexing. Micrometer Inf
ed. Miscellaneous Cams. Cabinet Base.
SPECIFICATIONS:
Capacity 3/22" - 2"
Drill Point Angles 40-180 deg.
Maximum Diameter of Tools 2.5"
Shank Diameter 2"
Tilt (Fore and Aft) 30 deg
Maximum Drill Length 16"
Wheel Diameter 7" x 1.25" x 1.25" Bore
Spindle Hole 2"
Chuck Diameter 6.5"
Infeed 0.001"
Approximate Weight 590 lbs
UED-ed is published by
Used Equipment Directory
45 Eisenhower Dr 5th Fl, Paramus NJ 07652
Robert Scofield, Publisher. Email: bobs@buyused.com,
Tel: 973-400-1790 Fax: 973-625-8933
|
